Search result
Front/Center/Surround/Surround Back
Set the correct audio output terminals for your speaker system.
Configuration
Select whether or not each speaker exists. For Surround Back speakers, select the number of speakers to be used.
[Front/Center/Surround]
|
Yes |
The selected speakers will be used. |
|
No: |
The selected speakers will not be used. |
[Surround Back]
|
2 spkrs |
Two Surround Back speakers will be used. |
|
1 spkr: |
Only one Surround Back speaker will be used. When you select this setting, connect to the SURROUND BACK L terminal. |
|
No: |
Surround Back speakers will not be used. |
“Front” is fixed as “Yes” as it is required for playback.
When “Surround” is set to “No”, “Surround Back” settings are automatically set to “No”.
Connection
Select the audio output terminal.
|
Spkr + Pre-out |
Speaker and pre-out outputs are active. |
|
Pre-out Only: |
Only pre-out terminals are active. Interference to the preamplifier can be reduced by turning off the signal path to the power amplifier. |
When “Amp Assign” is set to “Preamplifier”, the “Connection” setting of all speakers will be fixed as “Pre-out Only”.
When “Amp Assign” is set to “11.1ch” and 11 channels of speakers are used, at least one of the channels assigned to the Front channels, Height 2 or Surround Back must be set to “Pre-out Only”.