Playback

Operations cannot be performed through the remote control unit

Operations cannot be performed through the remote control unit.

Batteries are worn out. Replace with new batteries. link

Operate the remote control unit within a distance of about 23 ft/7 m from this unit and at an angle of within 30°. link

Remove any obstacle between this unit and the remote control unit.

Insert the batteries in the proper direction, checking the Thread-Plus and Tread-Minus marks. link

The set’s remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent bulb light, etc.). Move the set to a place in which the remote control sensor will not be exposed to strong light.

The operation target zone does not correspond to the zone setting specified on the remote control unit. Press the MAIN or Z2 button to select the operating zone of the remote control. link

When using a 3D video device, the remote control unit of this unit may not function due to effects of infrared communications between units (such as TV and glasses for 3D viewing). In this case, adjust the direction of units with the 3D communications function and their distance to ensure they do not affect operations from the remote control unit of this unit.

“ECO Mode” cannot be switched using ECO  Icon Eco on the remote control unit when the following settings are used. link
- When “Amp Assign” is set to “Preamplifier”link
- When speaker impedance is set to 4 Ω/ohms link

back to top