Playback

ZONE2 Setup

Makes settings for audio playback with ZONE2.

Values set for “Volume Limit” and “Power On Volume” are displayed according to the setting specified for the volume “Scale”. link

This can be set when “Amp Assign” is set to “5.1ch + ZONE2”. link

L Ch Level

Adjust the left channel output level.

-12 dB – +12 dB (Default : 0 dB)

R Ch Level

Adjust the right channel output level.

-12 dB – +12 dB (Default : 0 dB)

Volume Level

Set the volume output level.

Variable
(Default):

Volume can be adjusted.

1 – 98
(–79 dB – 18 dB):

Volume is fixed at the desired level. The volume cannot be adjusting using the remote control unit.

The dB value is displayed when the “Scale” setting is “ –79.5 dB – 18.0 dB”. link

Volume Limit

Make a setting for maximum volume.

60 – 80 (–20 dB – 0 dB)
(Default : 70 (-10 dB))

Off:

Do not set a maximum volume.

This can be set when “Volume Level” is set to “Variable”. link

The dB value is displayed when the “Scale” setting is “-79.5 dB - 18.0 dB”. link

Power On Volume

Sets the initial volume level when the power is turned on.

Last
(Default):

Sets the power-on level to the last-used volume level.

Mute:

Sets the power-on level to mute level.

1 – 98
(–79 dB – 18 dB):

Sets a specific power-on level.

This can be set when “Volume Level” is set to “Variable”. link

The dB value is displayed when the “Scale” setting is “-79.5 dB - 18.0 dB”. link

Mute Level

Set the amount of attenuation when mute is on.

Full
(Default):

Sets the mute level to full mute (no sound).

-40 dB :

Sets the mute level to 40 dB lower than the current volume level.

-20 dB :

Sets the mute level to 20 dB lower than the current volume level.

back to top