Search result
Firmware
Checks for the latest firmware information about updates, updates the firmware.
Check for Update
Check for firmware updates.
The firmware can be updated if a firmware update has been released.
|
Update Now: |
Execute the update process. When the update starts, the menu screen is shut down. During the update, the progress is shown on the display. |
|
Update Later: |
Update later. |
This unit automatically retries updating if updating fails. If an update still cannot be performed, an “Update Error” message appears in the display. See Troubleshootinglink – Update error messageslink for information on update error messages.link
Check the conditions according to the message and try the update again.
This menu cannot be selected when “Allow Update” is set to “Off”.
Auto-Update
Turns on Automatic Updates so that feature updates are automatically downloaded and installed when this unit is in standby mode.
Auto-Update
This unit will automatically update to the newest firmware when in standby mode.
|
On: |
Turns on Automatic Updates. |
|
Off |
Turns off Automatic Updates. |
Time Zone
Change the time zone.
Set the time zone that matches the area where you live.
This menu cannot be selected when “Allow Update” is set to “Off”.
Allow Update
Enable or disable updates for this unit.
|
On |
Enables this unit to receive updates. |
|
Off: |
Prevents this unit from receiving update. |
This setting causes Incompatibilities between this unit and HEOS App.
|
Notes concerning use of “Update” |
|
In order to use these functions, you must have the correct system requirements and settings for an Internet connection. link |
|
Do not turn off the power until updating is completed. |
|
Approximately 1 hour is required for the updating procedure to be completed. |
|
Once updating starts, normal operations on this unit cannot be performed until updating is completed. Furthermore, there may be cases where backup data is reset for the parameters, etc., set on this unit. |
|
If the update fails, press and hold the |
on the main unit for more than 5 seconds, or remove and re-insert the power cord. After about 1 minute, “Please wait” appears on the display and update restarts. If the error continues, check the network environment.