Playback

Power does not turn on / Power is turned off

Power does not turn on.

Check whether the power plug is correctly inserted into the power outlet. link

Power automatically turns off.

The sleep timer is set. Turn on the power again. link

“Auto Standby” is set. “Auto Standby” is triggered when there is no operation for a set amount of time. To disable “Auto Standby”, set “Auto Standby” on the menu to “Off”. link

Power turns off and the protection circuit indicator flashes in orange approx. every 2 seconds.

The protection circuit has been activated due to a rise in temperature within this unit. Turn the power off, wait about an hour until this unit cools down sufficiently, and then turn the power on again. link

Please re-install this unit in a place having good ventilation.

Power turns off and the protection circuit indicator flashes in orange approx. every 0.5 seconds.

Check the speaker connections. The protection circuit may have been activated because speaker cable core wires came in contact with each other or a core wire was disconnected from the connector and came in contact with the rear panel of this unit. After unplugging the power cord, take corrective action such as firmly re-twisting the core wire or taking care of the connector, and then reconnect the wire. link

Turn down the volume and turn on the power again. link

This unit’s amplifier circuit has failed. Unplug the power cord and contact our customer service center.

Power does not turn off even when the power button is pressed, and the display shows “ZONE2 On”.

The power supply of ZONE2 is turned to ON. To turn off the power supply of this unit (standby), press the POWER  Power Button button after pressing the Z2 button on the remote control unit to turn off the power supply of ZONE2.

back to top