Connecting the speaker cables

Carefully check the left (L) and right (R) channels and + (red) and - (white) polarities on the speakers being connected to this unit, and be sure to connect the channels and polarities correctly.

Peel off about 10 mm of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it.
Conn spCable1
Turn the speaker terminal counterclockwise to loosen it.
Conn spCable2 PM10
Insert the speaker cable’s core wire to the hilt into the speaker terminal.
Conn spCable3 PM10
Turn the speaker terminal clockwise to tighten it.
Conn spCable4 PM10

Spade lug connector

Conne Spade lug

back to top