Remembering remote control codes from other devices
The input source is shown in the remote control display.
LEARN indicator lights up.
If “NG” is shown on the remote control display, perform step 4 again.
The LEARN indicator turns off, and the remote control unit exits learn mode.
There are some remote control units that cannot be programmed, or even if they can be programmed, they may not operate correctly. If this happens, use the remote control unit supplied with the AV equipment to operate it.
If the remote control memory becomes full, “FULL” is shown on the remote control display. If you want to learn the code, you should erase other learned button.
The learning function is unavailable for all ZONE SELECT, SET, AVP, POWER , VOLUME , SMART SELECT, SOUND MODE and input source select buttons in any mode.
If no buttons are pressed for approximately 1 minutes while in the LEARN mode, the remote control unit automatically exits from the LEARN mode.