Search result
Specifying the zone used with the remote control unit
When the ZONE SELECT is pressed, only the set zone can be operated with the remote control unit.
This is useful for preventing mistaken operation.
The factory setting is “M23”.
Press and hold ZONE SELECT and SET for at least 3 seconds.
Use 
to set the zone to be used and press ENTER.
to set the zone to be used and press ENTER.“SET” flashes four times on the remote control unit and the normal operation mode is restored.
|
Remote control unit display |
Zone to be used |
|---|---|
|
M |
MAIN ZONE only |
|
M2 |
MAIN ZONE / ZONE2 |
|
M23 |
MAIN ZONE / ZONE2 / ZONE3 |