Status LED

Cannot connect to a network using an iOS device

This unit supports Apple’s “WAC (Wireless Accessory Configuration)” setup mode. WAC setup mode allows you to connect this unit to your network without requiring you to type in the network name and password.

The CONNECT LED on the rear of this unit will slowly blink amber to indicate that WAC setup mode is active. If the rear LED is not blinking amber, press and hold volume down (-) and Triangle Right Pause buttons on this unit for 3 seconds until you see the LED blinking amber.
On your iOS device, go to the Wi-Fi menu under Settings.
Select “Marantz MODEL M1” under “SET UP NEW AIRPLAY SPEAKER...” at the bottom of the list.
Select the network you want this unit to connect to and select “Next”.
Follow the instructions on the screen to complete setup.
When the connection is complete, the status LED on the front of this unit will turn solid white.

This unit will stay in WAC setup mode for 15 minutes. If this unit is not setup within 15 minutes, it will revert back to its previous network connection. Press the Triangle Right Pause button on this unit if you want to cancel WAC setup mode.

back to top