ZONE2 Setup

Configure the settings for audio playback on ZONE2.

Values set for “Volume Limit” and “Power On Volume” are displayed according to the setting specified for the volume “Scale”. link

Lch Level

Adjust the left channel output level.

-12 dB – +12 dB (Default : 0 dB)

Rch Level

Adjust the right channel output level.

-12 dB – +12 dB (Default : 0 dB)

Volume Level

Set the volume output level.

Variable
(Default):

Volume can be adjusted.

1 – 98
(–79.5 dB – 18.0 dB):

Volume is fixed at the desired level. The volume cannot be adjusting using the remote control unit.

Volume Limit

Make a setting for maximum volume.

60 (-20 dB) / 70 (-10 dB) / 80 (0 dB)
(Default : 70 (-10 dB))

Off:

Do not set a maximum volume.

This can be set when “Volume Level” is set to “Variable”. link

Power On Volume

Define the volume setting that is active when the power is turned on.

Last
(Default):

Use the memorized setting from the last session.

Mute:

Always use the muting on condition.

1 – 98
(–79.5 dB – 18.0 dB):

The volume is adjusted to the set level.

This can be set when “Volume Level” is set to “Variable”. link

Mute Level

Set the amount of attenuation when muting is on.

Full
(Default):

The sound is muted entirely.

–40 dB :

The sound is attenuated by 40 dB down.

–20 dB :

The sound is attenuated by 20 dB down.

This can be set when “Volume Level” is set to “Variable”. link

back to top