Overview

Accessories

Inserting the batteries
Operating range of the remote control unit
Part names and functions

Front panel
Rear panel
Remote control unit

Connections

Connections
Connecting speakers

Speaker A/B connection
Bi-wiring connection
Subwoofer connection
Connecting a playback device
Connecting a recording device
Connecting a pre-amplifier or power amplifier
Connecting devices with remote control connectors

Performing operations by RC on this unit without visual contact
Remotely connecting Marantz audio devices
Connecting the power cord

Playback

Playback

Turning the power on
Switching the power to standby
Selecting the speakers for audio output
Selecting the input source
Adjusting the volume
Turning off the sound temporarily (Muting)
Adjusting the tone and balance
Playback in source direct mode
Playing CDs
Using this unit as a power amplifier
Recording

Settings

Setting the display’s brightness
Setting the Auto Standby mode
Setting remote control codes

Setting remote control codes for the remote control
Setting remote control codes for the main unit

Tips

Tips
Troubleshooting

Power does not turn on / Power is turned off
Operations cannot be performed through the remote control unit
Display on this unit shows nothing
No sound comes out
Desired sound does not come out
Sound is interrupted or noise occurs

Appendix

Explanation of terms
Specifications
Dimensions / Weight
Index
PDF Download

Setting remote control codes for the remote control

To set the remote control codes to AMP1, AMP2 or AMP3

Hold down Button_Square White Mz and one of the number 1, 2 or 3 buttons for more than 5 seconds.

Set the remote control code to AMP1, AMP2 or AMP3 according to the selected number button.

NOTE

The remote control codes returns to the default settings when the batteries are removed. Set the remote control codes again after replacing the batteries.

back to top