Playback

TV Format

Set the video signal format to be output for the TV you are using.

Format

PAL
(Default):

Select PAL output.

NTSC:

Select NTSC output.

“Format” can also be set by the following procedure. However, the menu screen is not displayed. Following the display content to make the setting.

Press and hold the main unit’s STATUS and ZONE3 SOURCE at the same time for at least 3 seconds.

Flower Mark Video Format <PAL>” appears on the display.

Use the main unit’s cursor Left or cursor Right and set the video signal format.
Press the main unit’s ENTER to complete the setting.
NOTE

When a format other than the video format of the connected TV is set, the picture will not be displayed properly.

back to top