Graphic EQ

Uses the graphic equalizer to adjust the tone of each speaker.

Speakers for which “Graphic EQ” can be set differ according to the sound mode.

This can be set when the “MultEQ® XT32” is set to “Off”. link

This cannot be set when the sound mode is set to “Direct” or “Pure Direct”.

This cannot be set when the input mode is set to “7.1CH IN”.

Graphic EQ

Set whether to use the graphic equalizer or not.


Use the graphic equalizer.


Do not use the graphic equalizer.

Speaker Selection

Select whether to adjust tones for individual speakers or for all speakers.


Adjust all speaker tones together.


Adjust the left and right speaker tones together.


Adjust the tone for each speaker.

Adjust EQ

Adjust tonal balance for each frequency band. Adjust the speaker selected in “Speaker Selection”.

Select the speaker.
Select the adjustment frequency band.

63 Hz / 125 Hz / 250 Hz / 500 Hz / 1 kHz / 2 kHz / 4 kHz / 8 kHz / 16 kHz

Adjust the level.

–20.0 dB – +6.0 dB (Default : 0.0 dB)

Front Dolby, Surround Dolby and Back Dolby speakers can only be set when 63 Hz/125 Hz/250 Hz/500 Hz/1 kHz.

Curve Copy

Copy the Flat correction curve created in the Audyssey® Setup.

“Curve Copy” is displayed after Audyssey® Setup has been performed.

Set Defaults

The “Graphic EQ” settings are returned to the default settings.

back to top