TV Format
Set the video signal format to be output for the TV you are using.
Format
|
NTSC |
Select NTSC output. |
|
PAL: |
Select PAL output. |
“Format” can also be set by the following procedure. However, the menu screen is not displayed. Following the display content to make the setting.
Press and hold the main unit’s ZONE2 SOURCE and STATUS at the same time for at least 3 seconds.
“V.Format:<NTSC>” appears on the display.
Use the main unit’s ZONE2 SOURCE or INTERNET RADIO and set the video signal format.
Press the main unit’s STATUS to complete the setting.
NOTE
When a format other than the video format of the connected TV is set, the picture will not be displayed properly.