Configuring AVR settings

Before using Dirac Live software, follow the steps below to set up this unit.

Connect to a network.

Connect this unit and the computer where Dirac Live software is installed to the same network.
(Setting items: Setup Menu - Network - Connection)

Set the speaker preset (excluding the first time measurement is performed).

Select the speaker preset where you want to save the measurement results. If two speaker presets are already being used, the speaker preset you have selected will be overwritten with the measurement results.

When performing calibration with Dirac Live for the first time, saving to Speaker Preset 2 is performed automatically.

(Setting items: Setup Menu/Speakers/Manual Setup/Speaker Preset)

NOTE

When performing calibration with Dirac Live for the first time, the Speaker Layout and Crossover values from Preset 1 are copied.

When performing calibration with Dirac Live for the first time, overwriting is performed even when Preset 2 is in use.

Set the speaker layout.

Set the layout of the speakers you want to measure in Speaker Layout in the menu.
(Setting items: Setup Menu - Speakers - Manual Setup - Speaker Layout)

NOTE

The optional Dirac Live room correction feature calculates the proper gain and delay time for each speaker, however it does not calculate the crossover points. Please adjust the crossover points for your speakers using the AVR’s Setup Menu before performing Dirac Live calibration.
Setting Item : Setup Menu – Manual Setup – Crossovers
Crossovers are automatically set to a suitable setting when using Bass Management or Bass Control. 9-2 If using Bass Management or Dirac Live Bass Control™link

The measurement cannot be conducted when headphones are connected. If headphones are connected, unplug them before performing the Dirac Live measurement.