Playback

Front/Center/Surround/Surround Back/Front Wide

Set the correct audio output terminals for your speaker system.

Configuration

Select whether or not each speaker exists. For Surround Back speakers, select the number of speakers to be used.

[Front/Center/Surround/Front Wide]

Yes
(Default):

The selected speakers will be used.

No:

The selected speakers will not be used.

[Surround Back]

2 spkrs
(Default):

Two Surround Back speakers will be used.

1 spkr:

Only one Surround Back speaker will be used. When you select this setting, connect to the SURROUND BACK L terminal.

No:

Surround Back speakers will not be used.

“Front” is fixed as “Yes” as it is required for playback.

When “Surround” is set to “No”, “Surround Back” and “Front Wide” settings are automatically set to “No”.

Connection

Select the output terminals for audio from the speakers.

Spkr + Pre-out
(Default):

Speaker and pre-out outputs are active.

Pre-out Only:

Pre-out outputs are active. Speaker outputs are disconnected for enhanced audio quality using only the pre-out terminals.

When “Amp Assign” is set to “Preamplifier”, the “Connection” setting of all speakers will be fixed as “Pre-out Only”.

When “Amp Assign” is set to “13.1ch” and 13 channels of speakers are used, at least one of the channels assigned to the Front, Height 3 or Front Wide must be set to “Pre-out Only”.

back to top