Search result
DC CONTROL jacks
DC CONTROL OUT jack
When a device with DC CONTROL IN jack is connected, the connected device’s power on/standby can be controlled through linked operation to this unit.
The DC CONTROL OUT jack outputs a maximum 12 V DC/150 mA electrical signal.
NOTE
Use a monaural mini-plug cable for connecting the DC OUT jacks. Do not use a stereo mini-plug cable.
If the permissible trigger input level for the connected device is larger than 12 V DC/150 mA, or has shorted, the DC OUT jack cannot be used. In this case, turn off the power to the unit, and disconnect it.
DC CONTROL IN jack
Used when connecting a unit that has a DC CONTROL OUT jack to this device, and linking the power ON/STANDBY of the connected device with the power ON/STANDBY of this unit.
For details, see the instruction manual of the connected device.
NOTE
When a 5 V – 15 V voltage is input to the DC CONTROL IN jack, the power of this unit switches ON.
However, inputting voltage outside of this range will cause damage to this unit.
