Search result
Layout
Configuraiton
Set the speaker layout when installing 1 set (2-channels) of Height, Ceiling or Dolby Atmos Enabled speakers.
The layouts that can be selected differ depending on the combinations of “Amp Assign” and floor speaker settings in the menu. (Amp Assignlink, Front/Center/Surround/Surround Backlink)
[2-channel heigh speakes]
|
Settings |
AUDIO OUT connectors |
||
|---|---|---|---|
|
Height Speakers |
Layout |
HEIGHT 1 |
HEIGHT 2 |
|
None |
- |
- |
- |
|
2 spkrs |
Front Height |
Front Height |
- |
|
Top Front |
Top Front |
- |
|
|
Top Middle |
Top Middle |
- |
|
|
Top Rear |
Top Rear |
- |
|
|
Rear Height |
Rear Height |
- |
|
|
Front Dolby |
Front Dolby |
- |
|
|
Surround Dolby |
Surround Dolby |
- |
|
|
Back Dolby |
Back Dolby |
- |
|
1This can be selected when using Surround speakers. Set “Surround” in the menu to “Yes”. link
This can be selected when “Assign Mode” is set to “11.1ch” or “9.1ch” and “Surround Back” is used in the menu. link
Connection
Select the output terminals for Height speakers.
|
Spkr + Pre-out |
Speaker and pre-out outputs are active. |
|
Pre-out Only: |
Pre-out outputs are active. Speaker outputs are disconnected for enhanced audio quality using only the pre-out terminals. |
When “Amp Assign” is set to “Preamplifier”, the “Connection” setting of all speakers will be fixed as “Pre-out Only”.