2ch Playback

Select the method for setting the speakers used in the 2-channel direct and stereo playback modes.

Setting

Select the method for setting the speakers used in the 2-channel direct and stereo playback modes.


Auto (Default):	The settings in “Speakers” are applied.
Manual:	Set the speakers for 2-channel playback. Make the following settings.

Set the maximum frequency of the bass signal output from each channel to the subwoofer.


Full Range:	Select “Full Range” to set the speaker to play full-range audio.
40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz / 200 Hz / 250 Hz (Default: 80 Hz)	Selects the crossover point to send the low frequency sound to the subwoofer.

When “Speaker Layout” - “Subwoofers” in the menu is set to “No”, “Full Range” is automatically set. link

When “2ch Playback” - “Subwoofer” is set to “Yes”, “Full Range” is automatically set. link

Set the presence of a subwoofer.


Yes (Default):	Use a subwoofer.
No:	Select when a subwoofer is not connected.

When “Speaker Layout” - “Subwoofers” in the menu is set to “No”, No is automatically set. link

Selects which low frequency signals are sent to the subwoofer outputs.


LFE (Default):	When “2ch Playback” - “Crossover” is set to “Full Range”, only LFE signals are output from the subwoofer. Also, when “2ch Playback” - “Crossover” is set to other than “Full Range”, the front channel low range signals are added to the LFE signals and output from the subwoofer.
LFE + Main:	The front channel low range signal is added to the LFE signal output from the subwoofer.

This can be set when “2ch Playback” - “Subwoofer” is set to “Yes”.

Selects the low-pass filter point for the full-range speaker to copy the low frequency signal to subwoofer.


40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz / 200 Hz / 250 Hz (Default: 80 Hz)

This can be set when “2ch Playback” - “Crossover” is set to “Full Range”, and “2ch Playback” - “Subwoofer” is set to “Yes”.

Adjusts the amount of LFE signal sent to the full-range front speakers.


Off (Default):	Front Speakers do not play LFE signals.
–20 dB – 0 dB	Adjusts the amount of LFE signal sent to the front speakers

This can be set when “2ch Playback” - “Crossover” is set to “Full Range”, and “2ch Playback” - “Subwoofer” is set to “Yes”.

Set distance from main listening position to speaker.

The unit is “msec” when using “Dirac Live”.


0.0 ft – 59.1 ft (Default: 11.8 ft) / 0.00 m – 18.00 m (Default: 3.60 m)

Set the difference in the distance between the speakers to less than 19.7 ft (6.00 m).

[When using Dirac Live]


0.0 ms – 20.0 ms

Adjust the level of each channel.


-12.0 dB – +12.0 dB (Default: 0.0 dB)