Overview

Connections

Playback

Settings

Tips

Appendix

Connecting 13.1-channel speakers

Example connection when using three sets of ceiling speakers

Pict SP Layout 13.1 TF TR TM

Set “Floor” - “Layout” to “5ch & SB” and “Height Sp” to “6ch” in the menu when connecting in this configuration. link

Bracket Open Example Bracket Close  UNBALANCED RCA connector connection

Conne SP 13.1 TF TR TM A85U

You can change the combination of the HEIGHT1, HEIGHT2 and HEIGHT3 channels in the settings. link

Example connection when using two sets of height speakers and one set of ceiling speakers

Pict SP Layout 13.1 FH RH TM

Set “Floor” - “Layout” to “5ch & SB” and “Height Sp” to “6ch” in the menu when connecting in this configuration. link

Bracket Open Example Bracket Close  UNBALANCED RCA connector connection

Conne SP 13.1 FH RH TM A85U

You can change the combination of the HEIGHT1, HEIGHT2 and HEIGHT3 channels in the settings. link

Example connection when using two sets of height speakers and one set of front wide speakers

Pict SP Layout 13.1 FH RH FW

Set “Floor” - “Layout” to “5ch & SB & FW” and “Height Sp” to “4ch” in the menu when connecting in this configuration. link

Bracket Open Example Bracket Close  UNBALANCED RCA connector connection

Conne SP 13.1 FH RH FW A85U

You can change the combination of the HEIGHT1 and HEIGHT2 channels in the settings. link

Example connection when using three sets of Dolby Atmos Enabled speakers

Pict SP Layout 13.1 FD SD BD

Set “Floor” - “Layout” to “5ch & SB” and “Dolby Sp” to “6ch” in the menu when connecting in this configuration. link, link

Bracket Open Example Bracket Close  UNBALANCED RCA connector connection

Conne SP 13.1 FD SD BD A85U

You can change the combination of the HEIGHT1, HEIGHT2 and HEIGHT3 channels in the settings. link

Example connection for the Auro-3D 13.1-channel system

This speaker configuration is optimized for Auro-3D playback.

Pict SP Layout 13.1 Auro

Set “Floor” - “Layout” to “5ch & SB” and “Height Sp” to “6ch” in the menu when connecting in this configuration. link
Next, set “Height” - “Front Layout” to “Front Height & Center Height” and “Middle Layout” to “Surr. Height & Top Surround”. link

Bracket Open Example Bracket Close  UNBALANCED RCA connector connection

Conne SP 13.1 Auro A85U

You can change the combination of the HEIGHT1, HEIGHT2 and HEIGHT3 channels in the settings. link

For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup in place of Surround Height speakers.

back to top