Search result
Error messages
An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error message is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.
Examples |
Error details |
Measures |
---|---|---|
No speakers found. |
Sound calibration microphone is not detected. |
Connect the included Sound calibration microphone to the SETUP MIC jack of this unit. |
Not all speakers could be detected. |
Check the speaker connections. |
|
Ambient noise is too high or level is too low |
There is too much noise in the room. |
Either turn off any device generating noise or move it away. |
Perform again when the surroundings are quieter. |
||
Speaker or subwoofer sound is too low. |
Check the speaker installation and the direction in which the speakers are facing. |
|
Adjust the subwoofer’s volume. |
||
Front R : None |
The displayed speaker could not be detected. |
Check the connections of the displayed speaker. |
Front R : Phase |
The displayed speaker is connected with the polarity reversed. |
Check the polarity of the displayed speaker. |
For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure the connection is correct, press to select “Ignore”, then press ENTER. |