Overview

Connections

Playback

Settings

Tips

Appendix

Tips

I want the volume not to become too loud by mistake

Set the volume upper limit for “Volume Limit” in the menu beforehand. This prevents children or others from increasing the volume too much by mistake. link

I want to keep the volume at the same level when I turn the power on

By default, the volume setting when power was previously set to standby on this unit is applied at next power on with no change. To use a fixed volume level, set the volume level at power on for “Pow.On Volume” in the menu. link

I want to have the subwoofer always output audio

Depending on the input signals and sound mode, the subwoofer may not output audio. When “Subwoofer Mode” in the menu is set to “LFE+Main”, you can have the subwoofer always output audio. link

I want to make human voices in the movies clearer

Use “Dialog Level” in the menu to adjust the level. link

I want to keep bass and clarity during playback at a lower volume level

Set “Dynamic EQ” in the menu to “On”. This setting corrects the frequency characteristics to allow you to enjoy clear sound without the bass being lost even during playback at a lower volume level. link

I want to automatically adjust the volume level difference in content such as TV and movies

Set “Dynamic Volume” in the menu. Volume level changes (between quiet scenes and loud scenes) in TV shows or movies are automatically adjusted to your desired level. link

I want to set the optimized listening environment after changing the configuration/position of the speakers or changing a speaker to a new one.

Perform Audyssey® Setup. This automatically makes the optimized speaker settings for the new listening environment. link

I want to combine a desired video with the current music

Set “Video Select” in the option menu to “On”. You can combine the current music with your desired video source from a Set-top a Box or DVD, etc. while listening to music from the Tuner, Internet radio, USB or Bluetooth. link

I want to skip unused input sources

Set unused input sources for “Hide Sources” in the menu. This allows you to skip unused input sources when turning the INPUT SELECTOR knob on this unit. link

I want to operate this unit using the TV remote control

Select “AV Receiver” in a TV menu such as “Input” Flower Mark or “Operate Connected HDMI Device” Flower Mark . The Smart Menu of this unit is displayed on the TV. This Smart Menu can be operated using the remote control of your TV.

The selection method differs depending on your TV. See the owner's manual of your TV for details.

back to top