Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities on the speakers being connected to the unit, and be sure to connect the channels and polarities correctly.

Selecting speakers to output audio

You can set up this unit to output audio from Speaker A, Speaker B, or both.

Press SPEAKER A/B.

The current setting is displayed.

Press SPEAKER A/B again to change the settings.


Speaker A = On : Outputs audio from Speaker A only.
Speaker B = On : Outputs audio from Speaker B only.
Both Speakers A and B = On : Outputs audio from both Speaker A and Speaker B.

When using this connection, also set “Bi-Amp” in the menu to “Disable”. link

When “Both Speakers A and B = On” is set for the output audio speakers and AirPlay or Remote Play is used on an external devices or a Bluetooth operation is performed on an iOS device, the volume display on the external device or iOS device follows the volume of Speaker A.

Specifying speakers to adjust the volume

When 2 sets of speakers (Speaker A/Speaker B) are connected, either Speaker A or Speaker B can be selected for volume adjustment.

Press VOLUME A/B.

The speakers whose volume is to be adjusted are shown in the unit display.

Press VOLUME kurosankaku

to adjust the volume.

NOTE

This is only enabled when “Both Speakers A and B = On” is set for the audio output speakers.