Dirac Live

Filters exported from the Dirac Live software can be set by selecting Audio - Dirac Live Filter in the Setup Menu.

These settings are enabled after the filter is sent to the unit from the Dirac Live software.


Slot 1∗:	The Dirac Live filter that was exported to Slot 1 will be used.
Slot 2∗:	The Dirac Live filter that was exported to Slot 2 will be used.
Slot 3∗:	The Dirac Live filter that was exported to Slot 3 will be used.
Off:	Dirac Live filter will not be used.

Filter names created in Dirac Live Software will be displayed in the user interface.

You can store a maximum of 3 filters when using Dirac Live Software.

Only the slot to which the filter was exported can be selected.

When the sound mode is “Direct”, the acoustic filter will not be applied.

Dirac Live is automatically turned off when headphones are used.

You can also set filters in Option Menu - Dirac Live Filter.

You can also set filters in the HEOS app - Now Playing - Sound Options - Dirac Live Filter.

NOTE

After performing Dirac Live Room Calibration, if you change the subwoofer on/off setting in the menu through “Speakers”‐“Subwoofer”, the Dirac Live data will be lost. If you changed the subwoofer on/off setting, perform the calibration again. If the Dirac Live_® filter option is selected, there is no need to re-measure the subwoofer “Level” and “Crossover” when making changes after performing the Dirac Live calibration.

If the speaker output setting has already been set to Speaker B or Speaker A+B using the remote control’s SPEAKER A/B button, the Dirac Live filter setting will be changed to Off and the filter will not be available.