Configuring device settings

Before using Dirac Live software, follow the steps below to set up this unit.

Connect to a network.

Connect this unit and the computer where Dirac Live software is installed to the same network.

Set up the speakers.

Please set up each speaker according to the speaker configuration you will actually use.

NOTE

The optional Dirac Live room correction feature calculates the proper gain and delay time for each speaker, however it does not calculate the crossover points. When measuring with a subwoofer, please adjust the crossover points for your speakers using the device’s Settings Menu before performing Dirac Live calibration.
Setting Item: Setup Menu – Speakers – Subwoofer – Crossover

If the Amplifier Mode in the settings menu is set to Standard (A, B, or A+B), Dirac Live calibration will only be performed on Speaker A. If the speaker output setting has already been set to Speaker B or Speaker A+B using the remote control’s SPEAKER A/B button, that setting will be automatically changed to output sound only from Speaker A when communicating with the Dirac App.

The measurement cannot be conducted when headphones are connected. If headphones are connected, unplug them before performing the Dirac Live measurement.

If the Audio Out in the settings menu is set to Fixed and an external pre-main amplifier is connected, the calibration cannot be performed.