Configuring device settings

Before using Dirac Live software, follow the steps below to set up this unit.

Connect to a network.

Connect this unit and the computer where Dirac Live software is installed to the same network.
(Setting items: Setup Menu - Network - Connection)

Set up the speakers.

Please set up each speaker according to the speaker configuration you will actually use.

NOTE

The optional Dirac Live room correction feature calculates the proper gain and delay time for each speaker, however it does not calculate the crossover points. Please adjust the crossover points for your speakers using the device’s Settings Menu before performing Dirac Live calibration.
Setting Item: Settings – [your device name] – High Pass Filter/Wired Subwoofer – Low Pass Filter (If you are using a wireless subwoofer, please configure from [your Subwoofer name] –Low Pass Filter.)