Overview
Connections
Playback
Settings
Appendix
Upgrade (Auro-3D)
Network
To use this unit by connecting it to a home network (LAN), you must configure network settings.
If you set up your home network (LAN) via DHCP, set “DHCP” to “On”. (Use the default setting.) This allows this unit to use your home network (LAN).
When assigning an IP address to each device manually, you need to assign an IP address to this unit using the “IP Address” settings, and enter information about your home network (LAN) such as the gateway address and subnet mask, etc.
AV Pre Tuner
Copyright © 2014 D&M Holdings Inc. All Rights Reserved.