Specifications
Audio section
Analog
|
Input sensitivity/Input impedance: |
200 mV/47 kΩ/kohms |
|
Frequency response: |
10 Hz – 100 kHz — +1, –3 dB (Direct mode) |
|
S/N: |
105 dB (IHF–A weighted, Direct mode) |
|
Distortion: |
0.005 % (20 Hz – 20 kHz) (Direct mode) |
|
Rated output: |
Unbalanced XLR pre-output: 1.2 V |
|
Balanced XLR pre-output: 2.4 V |
Digital
|
D/A output: |
Rated output — 2 V (at 0 dB playback) |
|
Total harmonic distortion — 0.008 % (1 kHz, at 0 dB) |
|
|
S/N ratio — 102 dB |
|
|
Dynamic range — 100 dB |
|
|
Digital input: |
Format — Digital audio interface |
Phono equalizer
|
Input sensitivity: |
2.5 mV |
|
RIAA deviation: |
±1 dB (20 Hz to 20 kHz) |
|
S/N: |
74 dB (IHF-A) |
|
Rated output: |
150 mV |
|
Distortion factor: |
0.03 % (1 kHz, 3 V) |
Video section
Standard video connectors
|
Input/output level and impedance: |
1 Vp-p, 75 Ω/ohms |
|
Frequency response: |
5 Hz – 10 MHz — 0, –3 dB |
Color component video connector
|
Input/output level and impedance: |
Y signal — 1 Vp-p, 75 Ω/ohms PB / CB signal — 0.7 Vp-p, 75 Ω/ohms PR / CR signal — 0.7 Vp-p, 75 Ω/ohms |
|
Frequency response: |
5 Hz – 60 MHz — 0, –3 dB |
Tuner section |
[FM] |
[AM] |
|
|
(Note: μV at 75 Ω/ohms, 0 dBf = 1 x 10 –15 W) |
|
|
Reception frequency range: |
87.5 MHz – 108.0 MHz |
522 kHz – 1611 kHz |
|
Effective sensitivity: |
1.2 μV (12.8 dBf) |
18 μV |
|
50 dB sensitivity: |
MONO ― 2.8 μV (20.2 dBf) |
|
|
S/N ratio: |
MONO ― 70 dB (IHF–A weighted, Direct mode) STEREO ― 67 dB (IHF–A weighted, Direct mode) |
|
|
Distortion: |
MONO ― 0.7 % (1 kHz) STEREO ― 1.0 % (1 kHz) |
Wireless LAN section
|
Network type (wireless LAN standard): |
Conforming to Wi-Fi®∗1 |
|
Security: |
WEP 64 bit, WEP 128 bit |
|
WPA/WPA2-PSK (AES) |
|
|
WPA/WPA2-PSK (TKIP) |
|
|
Radio frequency: |
2.4 GHz |
|
No. of channels: |
1 – 13 ch |
The Wi-Fi® CERTIFIED Logo and the Wi-Fi CERTIFIED On-Product Logo are registered trademarks of the Wi-Fi Alliance.
Bluetooth section
|
Communications system: |
Bluetooth Version 2.1 + EDR (Enhanced Data Rate) |
|
Transmission power: |
Maximum 2.5 mW (Class 2) |
|
Maximum communication range: |
Approx. 10 m in line of sight∗2 |
|
Frequency band: |
2.4 GHz band |
|
Modulation scheme: |
FHSS (Frequency-Hopping Spread Spectrum) |
|
Supported profiles: |
A2DP (Advanced Audio Distribution Profile) 1.2 |
|
AVRCP (Audio Video Remote Control Profile) 1.4 |
|
|
Corresponding codec: |
SBC, AAC |
|
Transmission range (A2DP): |
20 Hz - 20,000 Hz |
The actual communication range varies depending on the influence of such factors as obstructions between devices, electromagnetic waves from microwave ovens, static electricity, cordless phones, reception sensitivity, antenna performance, operating system, application software etc.
General
|
Power supply: |
AC 230 V, 50/60 Hz |
|
Power consumption: |
60 W |
|
Power consumption in standby mode: |
0.2 W |
|
Power consumption in CEC standby mode: |
0.5 W |
|
Power consumption in network standby mode: |
2.7 W |
For purposes of improvement, specifications and design are subject to change without notice.