Playback

Playing digital input

Remote control unit illustration

Ope Digital IN RC014CR
Prepare for playback.

Check the connection, then turn on this units. (Connecting a digital devicelink)

Press OPTICAL IN to switch the input source to “Optical In 1” or “Optical In 2”.
Play the component connected to this unit.

If the sampling frequency cannot be detected, “Signal Unlock” will be displayed.

“Unsupported” is displayed when audio signals that are not supported by this unit are input.

When “TV Input” is set in the menu, this unit automatically turns on when the TV connected to the unit is turned on, and the input source switches to “Optical In 1” or “Optical In 2”. link

NOTE

Do not input non-PCM signals, such as Dolby Digital, DTS and AAC. This causes noise and could damage the speakers.

Specifications of supported audio formats

back to top