Specifying the zone used with the remote control unit

Ope ZoneOpe RC038

When the ZONE SELECT is pressed, only the set zone can be operated with the remote control unit.

This is useful for preventing mistaken operation.

The factory setting is “M23”.

Press and hold ZONE SELECT and SET for at least 3 seconds.
Use shirosankaku shirosankaku-Reverse to set the zone to be used and press ENTER.

“SET” flashes four times on the remote control unit and the normal operation mode is restored.

Remote control unit display

Zone to be used

M

MAIN ZONE only

M2

MAIN ZONE / ZONE2

M23

MAIN ZONE / ZONE2 / ZONE3

back to top