Rear panel

For details, see the next page.

Name Rear Small1 5011U

Rod antennas for Bluetooth/wireless LAN

Stand this antenna upright when connecting to a network via wireless LAN, or when connecting to a handheld device via Bluetooth. link

Pict AntennaAngle Mz

The antenna clip can be removed from the rear panel.

Rotate the antenna clip 90 degrees to the left.
Pull the antenna clip out towards yourself.

The antenna clip is needed when transporting this unit. Keep it in a safe place.

Attach the antenna clip by following the steps for removing it in reverse.


Used when using a control BOX or other such control devices to control this unit.

NETWORK connector

Used to connect to a LAN cable when connecting to a wired LAN network. link

Video connectors (VIDEO)

Used to connect devices equipped with video connectors.

Name Rear Small2 5011U

Digital audio connectors (DIGITAL AUDIO)

Used to connect devices equipped with digital audio connectors.

Component video connectors (COMPONENT VIDEO)

Used to connect devices equipped with component video connectors.

HDMI connectors

Used to connect devices equipped with HDMI connectors.

RS-232C connector

Used to connect home automation controller devices fitted with RS-232C connectors. Consult the owner’s manual of the home automation controller for more information about serial control of this unit.

Perform the operation below beforehand.

Turn on the power of this unit.
Turn off the power of this unit from the external controller.
Check that the unit is in the standby mode.
Name Rear Small3 5011U

DC OUT jack

Used to connect devices equipped with the trigger function. link

FM/AM antenna terminals (ANTENNA)

Used to connect FM antennas and AM loop antennas. link

Analog audio connectors (AUDIO)

Used to connect devices equipped with analog audio connectors.

7.1-channel input connectors (7.1CH IN)

Used to connect to a device that has multi-channel audio output connectors. link

Speaker terminals (SPEAKERS)

Used to connect speakers. link

PRE OUT connectors

Used to connect a subwoofer with built-in amplifier or an external power amplifier.


Used to connect infrared receivers/transmitters in order to operate this unit and external devices from a different room. link

AC inlet (AC IN)

Used to connect the power cord. link


Do not touch the inner pins of the connectors on the rear panel. Electrostatic discharge may cause permanent damage to the unit.

back to top