Search result
Error messages
When multiple PM-12 SE units are connected by F.C.B.S., the error messages described in the table below may be displayed on the display. In such a case, ID number setting or remote cable connection may be in failure. Check the ID number or remote cable connection, referring to the table below. For details on ID number setting, see How to set ID number for F.C.B.S.link.
|
Indication |
Meaning |
Cause / Solution |
|---|---|---|
|
ERROR 02 |
Multiple amplifiers take ID No.2. |
Assign different ID numbers to the amplifiers. |
|
ERROR 03 |
Multiple amplifiers take ID No.3. |
|
|
ERROR 04 |
Multiple amplifiers take ID No.4. |
|
|
ERROR 11 |
The amplifiers with ID No.2-4 cannot communicate with the amplifier with ID No.1. |
If the amplifier with ID No.1 is not on, turn it ON. Check that the remote cable is properly connected. |
|
ERROR 12 |
The amplifier with ID No.1 cannot communicate with the amplifiers with ID No.2-4. |
If multiple amplifiers take ID No.1, set ID numbers properly. If the amplifier with ID No.1 is connected to the amplifier with ID No.0, set ID numbers properly. Check that the remote cable is properly connected. |