Overview

Connections

Playback

Settings

Tips

Appendix

Preparation for F.C.B.S. connection

Making the F.C.B.S. connection

To use multiple PM-10 units, make this connection in addition to audio connection.

For details on each connection feature, refer to the respective instructions.

Prepare the correct number of portable audio connection cables for the number of units to be connected. Either of the following types of connection cables are adequate.

Φ3.5 Monaural mini plug Left Arrow   Right Arrow Φ3.5 monaural mini plug connecting cable

Cable Monaural mini plug

Φ3.5 Stereo mini plug Left Arrow   Right Arrow Φ3.5 stereo mini plug connecting cable

Cord Stereo mini plug
NOTE

Do not use connecting cables that contain resistance.

Connection example

In the connection of the following example, an unit with ID number 1 acts as a master amplifier to control all the other slave units with ID numbers 2 to 4.

Conne F.C.B.S PM10
NOTE

The PM-10 F.C.B.S. function is only valid between the same PM-10 models.

To turn the power of multiple F.C.B.S.-connected units ON/OFF, switch the power ON in order of lowest to highest ID number, and switch the power OFF in order of highest to lowest ID number.

How to set ID number for F.C.B.S.

When the unit is turned on, the display shows the ID number for three seconds.

For a master unit, ID number 1 needs to be assigned.

For a slave unit, set any of ID numbers 2 to 4.

Set F.C.B.S. ID PM10
While holding F.C.B.S. ID on the rear panel, press Power Button .
Turn INPUT SELECTOR on the unit to select an ID number.
Turn the unit off.
Again turn the unit on.

The setting is saved.

The unit registered as a slave shows “SLAVE” on the display.

NOTE

If using this unit by itself as a stereo amplifier, set the ID number to “0” (Default setting is “0”).

If the ID number is set to a number other than “0”, this unit cannot be used for standalone operation.

back to top