Search result
Connect and playback from a digital device (COAX/OPT1/OPT2)
Press COAX, OPT1 or OPT2 to switch the input source to “COAX”, “OPT1” or “OPT2”.
The digital audio signal that is being input is shown as follows in the display.
|
“COAX |
or |
“OPT1 |
or |
“OPT2 |
|
xxxxk” |
xxxxk” |
xxxxk” |
(xxxx is the sampling frequency.)
If the sampling frequency cannot be detected, “Unlocked” will be displayed.
“Unsupported” is displayed when audio signals that are not supported by this unit are input.
Specifications of supported audio formats
See D/A converterlink.
NOTE
Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise and could damage the speakers.
If the sampling frequency switches, such as from A mode to B mode in a CS broadcast, muting may operate for 1 – 2 seconds, cutting the sound.