Search result
ZONE2 Setup / ZONE3 Setup
Makes settings for audio playback with ZONE2 and ZONE3.
Values set for “Volume Limit” and “Power On Volume” are displayed according to the setting specified for the volume “Scale”. link
Bass
Adjust bass.
|
-10dB – +10dB (Default : 0dB) |
Treble
Adjust treble.
|
-10dB – +10dB (Default : 0dB) |
High Pass Filter
Make settings for cutting the low range to reduce distortion in the bass.
|
On: |
The low range is attenuated. |
|
Off |
The low range is not attenuated. |
Lch Level
Adjust the left channel output level.
|
-12 dB – +12 dB (Default : 0 dB) |
Rch Level
Adjust the right channel output level.
|
-12 dB – +12 dB (Default : 0 dB) |
Channel
Set whether to playback in stereo or monaural.
|
Stereo |
Stereo playback. |
|
Mono: |
Monaural playback. |
HDMI Audio(ZONE2 only)
Selects the audio signal format for playing an HDMI source in ZONE2.
|
Through |
The HDMI audio signal is passed through this unit to the device in ZONE2. |
|
PCM: |
The HDMI audio signal input into this unit is converted to a PCM signal that can be output from the ZONE2 PRE OUT connectors. |
Volume Level
Set the volume output level.
|
Variable |
Volume can be adjusted. |
|
1 – 98 |
Volume is fixed at the desired level. The volume cannot be adjusting using the remote control unit. |
The dB value is displayed when the “Scale” setting is “ –79.5 dB – 18.0 dB”. link
Volume Limit
Make a setting for maximum volume.
|
60 (-20 dB) / 70 (-10 dB) / 80 (0 dB) |
|
|
Off: |
Do not set a maximum volume. |
Power On Volume
Define the volume setting that is active when the power is turned on.
|
Last |
Use the memorized setting from the last session. |
|
Mute: |
Always mute when power is turned on. |
|
1 – 98 |
The volume is adjusted to the set level. |
Mute Level
Set the amount of attenuation when muting is on.
|
Full |
The sound is muted entirely. |
|
-40 dB : |
The sound is attenuated by 40 dB down. |
|
-20 dB : |
The sound is attenuated by 20 dB down. |