Search result
Rear panel
Bluetooth/wireless LAN antenna connectors
Used to connect the included external antennas for Bluetooth/wireless connectivity when connecting to a network via wireless LAN, or when connecting to a handheld device via Bluetooth. link
Place the external antennas for Bluetooth/wireless connectivity evenly over the screw terminal of rear.
Turn clockwise until the antennas is fully connected.
Rotate the antenna upwards for best reception.
SIGNAL GND terminal
Used to connect a ground wire for the turntable. link
USB port (POWER SUPPLY)
Can be used to power streaming media players, etc.
Use a device’s supplied AC adapter when a power supply of 5 V/1.5 A or more is required.
Connect to the USB port on the front panel to play content from a USB memory device.
Analog audio connectors (AUDIO)
Used to connect devices equipped with analog audio connectors.
NETWORK connector
Used to connect to a LAN cable when connecting to a wired LAN network. link
7.1-channel input connectors (7.1CH IN)
Used to connect to a device that has multi-channel audio output connectors. link
HDMI connectors
Used to connect devices equipped with HDMI connectors.
UNBALANCED RCA PRE OUT connectors
Used to connect a power amp with UNBALANCED RCA input connectors. link
Video connectors (VIDEO)
Used to connect devices equipped with video connectors.
Component video connectors (COMPONENT VIDEO)
Used to connect devices equipped with component video connectors.
AC inlet (AC IN)
Used to connect the power cord. link
BALANCED XLR IN connectors
Used to connect devices equipped with BALANCED XLR output connectors. link
FLASHER IN jack
Used when using a control BOX or other such control devices to control this unit.
REMOTE CONTROL jacks
Used to connect infrared receivers/transmitters in order to operate this unit and external devices from a different room. link
Digital audio connectors (DIGITAL AUDIO)
Used to connect devices equipped with digital audio connectors.
BALANCED XLR PRE OUT connectors
Used to connect a power amp with BALANCED XLR input connectors. link
DC OUT jacks
Used to connect devices equipped with the trigger function. link
RS-232C connector
Used to connect home automation controller devices fitted with RS-232C connectors. Consult the owner’s manual of the home automation controller for more information about serial control of this unit.
Perform the operation below beforehand.
Turn on the power of this unit.
Turn off the power of this unit from the external controller.
Check that the unit is in the standby mode.
NOTE
Do not touch the inner pins of the connectors on the rear panel. Electrostatic discharge may cause permanent damage to the unit.