Search result
Bass
Set subwoofer and LFE signal range playback.
Subwoofer Mode
Select low range signals to be reproduced by subwoofer.
|
LFE |
The low range signal of the channel set to “Small” speaker size is added to the LFE signal output from the subwoofer. |
|
LFE+Main: |
The low range signal of all channels is added to the LFE signal output from the subwoofer. |
“Subwoofer Mode” can be set when “Speaker Config.” - “Subwoofer” in the menu is set to other than “None”. link
Play music or a movie source and select the mode offering the strongest bass.
If “Speaker Config.” - “Front” and “Center” are set to “Large”, and “Subwoofer Mode” is set to “LFE”, no sound may be output from the subwoofers, depending on the input signal or selected sound mode. link
Select “LFE+Main” if you want the bass signals to always be produced from the subwoofer.
The audio settings in “IMAX Audio Settings” are applied during IMAX playback. link
LPF for LFE
Set LFE signal playback range. Set this when you want to change the playback frequency (low pass filter point) of the subwoofer.
|
80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz / |
The audio settings in “IMAX Audio Settings” are applied during IMAX playback. link