Registering preset codes

There are two methods for registering preset codes; the simple method for registering preset codes of Marantz players, the method for registering the preset numbers of other manufacturers’ devices, and the method for experimenting with preset codes one by one for registration.

Registering Marantz Players

Use the following simple method to register the preset codes of Marantz Blu-ray Disc players, DVD players and CD players.

Registering Blu-ray Disc Players

Press and hold down Blu-ray and OPTION until “OK” indicator on the remote control display is flashing, then release.

Registering DVD Players

Press and hold down DVD and OPTION until “OK” indicator on the remote control display is flashing, then release.

Registering CD Players

Press and hold down CD and OPTION until “OK” indicator on the remote control display is flashing, then release.

Registering multiple players at the same time

Press and hold down the SMART SELECT 1 – 4 and OPTION until “OK” indicator on the remote control display is flashing, then release.

Devices to be registered at the same time

Press and hold down the buttons

Blu-ray Disc player

DVD player

CD player

check_mark

check_mark

SMART SELECT 1 and OPTION

check_mark

check_mark

SMART SELECT 2 and OPTION

 

check_mark

check_mark

SMART SELECT 3 and OPTION

check_mark

check_mark

check_mark

SMART SELECT 4 and OPTION

NOTE

Depending on the model and year of manufacture of your device, some buttons may not operate. In this case, try “Registering by entering preset numbers” link.

Registering by entering preset numbers

Before starting, confirm the preset number of the device that you want to register and the buttons that can be registered in the “Preset Code Table” link in the Appendix.

Press and hold down the input source select button that you want to register the preset code to and SET until “PRSET” indicator on the remote control display is flashing, then release.
Enter the preset number (4 digits) listed for the device in the Preset Code Table using the number buttons (0 – 9) on the remote control.

Some manufacturers use more than one type of remote control code. Preset codes to change the number and verify correct operation.

If the device does not operate even when the preset code is registered, use the learning function. Remote codes for different devices can be remembered for use by the Marantz remote control included with this device. link

To unregister the device from a button and reset to the default setting, set the AVP code “0000” to the button.

NOTE

Depending on the model and year of manufacture of your device, some buttons may not operate.

Experimenting with preset codes one by one for registration

Switch the power on of the device for which you want to set the preset code.
Press and hold down the input source select button that you want to register the preset code to and SET until “PRSET” indicator on the remote control display is flashing, then release.
Aim the remote control at the appliance and slowly alternate between pressing CH/PAGE kurosankaku and DEVICE Power Button for the appliance.

The preset code is shown in the remote control display.

Stop when the appliance turns off.
Press ENTER once to lock in the code.

Some manufacturers use more than one type of remote control code. Preset codes to change the number and verify correct operation.

If the device does not operate even when the preset code is registered, use the learning function. Remote codes for different devices can be remembered for use by the Marantz remote control included with this device. link

NOTE

Depending on the model and year of manufacture of your device, some buttons may not operate.

back to top