Search result
Graphic EQ
Uses the graphic equalizer to adjust the tone of each speaker.
Speakers for which “Graphic EQ” can be set differ according to the sound mode.
This can be set when the “MultEQ® XT” setting is “Off”. link
This cannot be set when the sound mode is set to “Direct” or “Pure Direct”.
If you are using headphones, you can set the equalizer for headphones. link
This cannot be set when the input mode is set to “7.1CH IN”.
Graphic EQ
Set whether to use the graphic equalizer or not.
|
On: |
Use the graphic equalizer. |
|
Off |
Do not use the graphic equalizer. |
When using headphones
Headphone EQ
Set whether to use the graphic equalizer for headphones or not.
|
On: |
Use the graphic equalizer for headphones. |
|
Off |
Do not use the graphic equalizer for headphones. |
Speaker Selection
Select whether to adjust tones for individual speakers or for all speakers.
|
All: |
Adjust all speaker tones together. |
|
Left/Right |
Adjust the left and right speaker tones together. |
|
Each: |
Adjust the tone for each speaker. |
Adjust EQ
Adjust tonal balance for each frequency band.
Select the speaker.
Select the adjustment frequency band.
63 Hz / 125 Hz / 250 Hz / 500 Hz / 1 kHz / 2 kHz / 4 kHz / 8 kHz / 16 kHz
Adjust the level.
–20.0 dB – +6.0 dB (Default : 0.0 dB)
Front Dolby and Surround Dolby speakers can only be set when
Curve Copy
Copy the Flat correction curve created in the Audyssey® Setup.
“Curve Copy” is displayed after Audyssey® Setup has been performed.
“Curve Copy” cannot be used when using headphones.
Set Defaults
The “Graphic EQ” settings are returned to the default settings.