Graphic EQ
Uses the graphic equalizer to adjust the tone of each speaker.
Speakers for which “Graphic EQ” can be set differ according to the sound mode.
This can be set when the “MultEQ® XT” setting is “Off”. link
This cannot be set when the sound mode is set to “Direct” or “Pure Direct”.
Graphic EQ
Set whether to use the graphic equalizer or not.
|
On: |
Use the graphic equalizer. |
|
Off |
Do not use the graphic equalizer. |
Speaker Selection
Select whether to adjust tones for individual speakers or for all speakers.
|
All: |
Adjust all speaker tones together. |
|
Left/Right |
Adjust the left and right speaker tones together. |
|
Each: |
Adjust the tone for each speaker. |
Adjust EQ
Adjust tonal balance for each frequency band. Adjust the speaker selected in “Speaker Selection”.
Select the speaker.
Select the adjustment frequency band.
63 Hz / 125 Hz / 250 Hz / 500 Hz / 1 kHz / 2 kHz / 4 kHz / 8 kHz / 16 kHz
Adjust the level.
–20.0 dB – +6.0 dB (Default : 0.0 dB)
Curve Copy
Copy the Flat correction curve created in the Audyssey® Setup.
“Curve Copy” is displayed after Audyssey® Setup has been performed.
Set Defaults
The “Graphic EQ” settings are returned to the default settings.