Rear panel
Rod antennas for Bluetooth/wireless LAN
Stand this antenna upright when connecting to a network via wireless LAN, or when connecting to a handheld device via Bluetooth. link
The antenna clip can be removed from the rear panel.
Rotate the antenna clip 90 degrees to the left.
Pull the antenna clip out towards yourself.
The antenna clip is needed when transporting this unit. Keep it in a safe place.
Attach the antenna clip by following the steps for removing it in reverse.
Analog audio connectors (AUDIO)
FLASHER IN jack
Used when using a control BOX or other such control devices to control this unit.
NETWORK connector
Used to connect to a LAN cable when connecting to a wired LAN network. link
PRE OUT connectors
Digital audio connectors (DIGITAL AUDIO)
Component video connectors (COMPONENT VIDEO)
HDMI connectors
AC inlet (AC IN)
Used to connect the power cord. link
DC OUT jack
Used to connect devices equipped with the trigger function. link
RS-232C connector
Used to connect home automation controller devices fitted with RS-232C connectors. Consult the owner’s manual of the home automation controller for more information about serial control of this unit.
FM/AM antenna terminals (ANTENNA)
Used to connect FM antennas and AM loop antennas. link
7.1-channel input connectors (7.1CH IN)
Used to connect to a device that has multi-channel audio output connectors. link
Video connectors (VIDEO)
Speaker terminals (SPEAKERS)
Used to connect speakers. link
REMOTE CONTROL jacks
Used to connect infrared receivers/transmitters in order to operate this unit and external devices from a different room. link
NOTE
Do not touch the inner pins of the connectors on the rear panel. Electrostatic discharge may cause permanent damage to the unit.