Search result
Rear panel
Bluetooth/wireless LAN antenna connectors
Used to connect the included external antennas for Bluetooth/wireless connectivity when connecting to a network via wireless LAN, or when connecting to a handheld device via Bluetooth. link
Place the external antennas for Bluetooth/wireless connectivity evenly over the screw terminal of rear.
Turn clockwise until the antennas is fully connected.
Rotate the antenna upwards for best reception.
AUDIO OUT connectors
Used to connect devices equipped with analog audio inputs connectors or an external power amplifier. link
USB port ( 
)
This is used to connect USB storages (such as USB memory devices).
link
NETWORK connector
Used to connect to a LAN cable when connecting to a wired LAN network. link
DIGITAL AUDIO OUT connectors
Used to connect an AV receiver or D/A converter that has a digital input connectors. link
DIGITAL AUDIO IN connectors
Used to connect a computer or devices equipped with digital audio output connectors. link
FLASHER IN jack
Used to connect a control box, etc. link
RS-232C connector
Used to connect home automation controller devices fitted with RS-232C connectors. Consult the owner’s manual of the home automation controller for more information about serial control of this unit.
Perform the operation below beforehand.
Turn on the power of this unit.
Turn off the power of this unit from the external controller.
Check that the unit is in the standby mode.
REMOTE CONTROL connectors
Used to connect to a Marantz audio device that is compatible with the remote control function. link
EXTERNAL/INTERNAL switch
Turn this switch to “EXTERNAL” to operate the unit by pointing the remote control at the amplifier connected to this unit using the remote control connection. link
AC inlet (AC IN)
Used to connect the power cord. link