Adjusting the volume balance (LEVEL) and sound quality (BASS/TREBLE)

Adjusting LEVEL

The volume level of the left and right channels can be trimmed in 0.5 dB steps across a 0.0 - -9.0 dB range.

The factory default setting is 0.0 dB (maximum).

Press MODE/TRIM.

The unit enters LEVEL adjustment mode.

If the slave link is connected by F.C.B.S., the device for to adjust the volume balance (LEVEL) and sound quality (BASS/TREBLE) can be switched by pressing this button.

Press White-Arrow-Left White-Arrow-Right to select the channel that you wish to configure (L or R).

The level value of the selected channel flashes.

Use shirosankaku shirosankaku-Reverse to adjust the volume.

If there is no operation for 15 seconds, the setting is committed and the unit returns to the standard display.

Press ENTER.

This exits LEVEL adjustment mode and enters BASS adjustment mode. Follow steps 3 onward of “Adjusting BASS” to adjust the bass.

Adjusting BASS

The bass volume can be adjusted in 1 dB steps across a -6 - +6 dB range. The factory default setting is 0 dB.

Press MODE/TRIM.

The unit enters LEVEL adjustment mode.

Press ENTER to select “BASS”.

The unit enters BASS adjustment mode.

Press shirosankaku shirosankaku-Reverse to adjust the bass volume.

If there is no operation for 15 seconds, the setting is committed and the unit returns to the standard display.

Press ENTER.

This exits BASS adjustment mode and enters TREBLE adjustment mode. Follow steps 3 onward of “Adjusting TREBLE” to adjust the treble.

Settings are not applied when tone control is turned off. Press TONE to turn on tone control (TONE indicator lights).

Adjusting TREBLE

The treble volume can be adjusted in 1 dB steps across a -6 - +6 dB range. The factory default setting is 0 dB.

Press MODE/TRIM.

The unit enters LEVEL adjustment mode.

Press ENTER twice to select “TREBLE”.

The unit enters TREBLE adjustment mode.

Press shirosankaku shirosankaku-Reverse to adjust the treble volume.

If there is no operation for 15 seconds, the setting is committed and the unit returns to the standard display.

Press ENTER.

This exits TREBLE adjustment mode and returns to the normal display.

Settings are not applied when tone control is turned off. Press TONE to turn on tone control (TONE indicator lights).

back to top