Search result
Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + (red) and - (white) polarities on the speakers being connected to this unit, and be sure to connect the channels and polarities correctly.
Peel off about 3/8 inch (10 mm) of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it.
![Conn spCable1](fig/Conn spCable1_RQIFILgpgmxbso.png)
Turn the speaker terminal counterclockwise to loosen it.
![Conn spCable2 PM10](fig/Conn spCable2 PM10_OBAOILlrpruhpz.png)
Insert the speaker cable’s core wire to the hilt into the speaker terminal.
![Conn spCable3 PM10](fig/Conn spCable3 PM10_OBAOILmvlyawyp.png)
Turn the speaker terminal clockwise to tighten it.
![Conn spCable4 PM10](fig/Conn spCable4 PM10_OBAOILjfvcbtuy.png)
Spade lug connector |
---|
![]() |
When using a banana plug |
---|
![]() |