Power does not turn on / Power is turned off

Power is not turned on.

Check whether the power plug is correctly inserted into the power outlet. link

This unit is in standby mode. Press the Power Button button on the unit or the AMP Power Button button on the remote control. link

Power automatically turns off.

The sleep timer is set. Turn on the power again. link

“Auto-Standby” is set. “Auto-Standby” is triggered when there is no operation for a set amount of time. To disable “Auto-Standby”, set “Auto-Standby” on the menu to “Off”. link

Power turns off and the power indicator flashes in red approx. every 2 seconds.

The protection circuit has been activated due to a rise in temperature within this unit. Turn the power off, wait about an hour until this unit cools down sufficiently, and then turn the power on again. link

Please re-install this unit in a place having good ventilation.

Check the speaker connections. The protection circuit may have been activated because speaker cable core wires came in contact with each other or a core wire was disconnected from the connector and came in contact with the rear panel of this unit. After unplugging the power cord, take corrective action such as firmly re-twisting the core wire or taking care of the connector, and then reconnect the wire. link

Turn down the volume and turn on the power again. link

If this does not solve the issue, the amplifier circuit in the unit has malfunctioned. Unplug the power cord and contact our customer service center.

Power turns off and the power indicator flashes in red approx. every 0.5 seconds.

The power circuit in the unit has malfunctioned. Unplug the power cord and contact our customer service center.

back to top