Search result
Connecting an HD Radio antenna
After connecting the antenna and receiving a broadcast signal, fix the antenna with tape in a position where the noise level becomes minimal. (Listening to an HD Radio™ stationslink)
If you are unable to receive a good broadcast signal, we recommend installing an outdoor antenna. For details, inquire at the retail store where you purchased the unit.
NOTE
Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.
![Conne HD Radio AV7702IIU](fig/Conne HD Radio AV7702IIU_DRDZILpfciqwza.png)
Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
![Conne AM antenna1](fig/Conne AM antenna1_SEHFILjcttuysp.png)
Standing alone
Use the procedure shown above to assemble.
When assembling, refer to “AM loop antenna assembly”.
![Conne AM antenna2](fig/Conne AM antenna2_SEHFILvdqiixmk.png)
AM loop antenna assembly
Put the stand section through the bottom of the loop antenna from the rear and bend it forward.
Insert the projecting part into the square hole in the stand.
![Conne AM antenna](fig/Conne AM antenna_SEHFILdrkxbmjq.png)