ECO

Configure the ECO Mode and auto standby mode settings.

ECO Mode

This mode can reduce the power consumption and heat generation of your AV receiver when power on.

This is done by reducing the power supply line to the power amplifier, in turn the maximum power output.

On:

Power savings are always active, regardless of volume or input signal.

Auto:

Gives you the best balance between power savings and maximum power output:

For low volume levels, the power savings are active. If you increase the volume level, the power savings are switched off automatically, so you can enjoy maximum output power without distortion.

If the volume is set to a high level but no input signal is detected for more than 2 minutes, this unit will enable power savings. When an input signal is detected again or the input source is changed, this unit will automatically turn off power savings again at high volume levels.

Off
(Default):

No power savings.

When the unit is switching between the different power saving states in “ECO Mode: Auto”, you may notice a click noise from the inside of this unit, this is normal.

If content is paused for more than 2 minutes and playback is resumed from the same source at these high volume levels, there may be short delay before maximum power is restored.

“ECO Mode” can also be switched by pressing ECO  Icon Eco on the remote control unit.

Power On Default

Set the mode to ECO when the power is on.

 

Text

Last
(Default):

The ECO Mode will be set to the previous setting before the power was switched off.

On:

When power is turned on, the mode will always be switched to the ECO Mode in “On”.

Auto:

When power is turned on, the mode will always be switched to the ECO Mode in “Auto”.

Off:

When power is turned on, the mode will always be switched to the ECO Mode in “Off”.

On Screen Display

Display the power consumption of this unit using a meter on the TV screen.

Title

Text

Always On:

Always display the meter on the TV screen.

Auto
(Default):

Display the meter when changing the mode or volume.

Off:

Do not display the meter.

Auto Standby

Set so the unit power automatically switches to standby.

MAIN ZONE

Sets the time for switching to auto standby when there are no audio or video signals input into this unit.
Before the unit enters standby mode, “Auto Standby” is displayed on the unit display and the menu screen.

Title

Text

60 min:

The unit goes into standby after 60 minutes.

30 min:

The unit goes into standby after 30 minutes.

15 min:

The unit goes into standby after 15 minutes.

Off
(Default):

The unit does not go into standby automatically.

ZONE2

When there are no operations for a certain period of time as set here, the power is automatically shut off even if there is audio or video input.

Title

Text

8 hours:

Switches ZONE2 the standby state after about 8 hours.

4 hours:

Switches ZONE2 to the standby state after about 4 hours.

2 hours:

Switches ZONE2 to the standby state after about 2 hours.

Off
(Default):

Does not automatically switch ZONE2 to the standby state.

back to top