Playback

TV Format

Set the video signal format to be output for the TV you are using.

Format

NTSC
(Default):

Select NTSC output.

PAL:

Select PAL output.

“Format” can also be set by the following procedure. However, the menu screen is not displayed. Following the display content to make the setting.

Press and hold the main unit’s STATUS and ZONE SELECT at the same time for at least 3 seconds.

Flower Mark Video Format <NTSC>” appears on the display.

Use the main unit’s White-Arrow-Left or White-Arrow-Right and set the video signal format.
Press the main unit’s ENTER to complete the setting.
NOTE

When a format other than the video format of the connected TV is set, the picture will not be displayed properly.

back to top